LRMAX HAGE Led design

This model is best for office and interior. It can be configured for light regulation and turning on and off internal LED modules (or light spots).
The power, the light output and the lenght of the appliance depends on the number of light spots you decide to order.
Anodized aluminium is recommended when aesthetic is important. Non-anodized aluminium is cheaper and recommended when aesthetic is not important or when the casing is not visible. Both offer excelent mechanical protection.
It can be mounted horizontaly under a ceiling or vertically on a wall or suspended with cables.
Other anodizing colours can be ordered for orders including more than 300 meters of total appliance lenght or for smaller orders with an extra cost covering the customized anodizing service.

Indoor use only. This model is not water proof. For outdoor use, a rain protection kit can be ordered on demand.

The pictures below show how the lights are gradualy turned off, half turned on and all turned on.
This model has 7 light spots typically adjusted between 50W (6000 lm) and 70W (8400 lm).
Each of them can be set to be turned on or off when the secondary switch is actuated.
The same model can be made with less or more light spots, different lenghts and different options.

View from the side of the appliance.

View from below the ceiling.

These views showing from another angle how the lights are fully turned on, half turned off and all turned off.

Close view of the side lid.

Another variant with the light effects when there is no side lid.

View inside one variant of the LRMAX model.
Different parts and power supplies can be assembled according to the client's preference.